For anyone interested -
If you have the same exact amplitude, phase and frequency on each out then nothing is sent. So choose a different waveform on each outs or use inverse and sync.
i'm using inverse & sync (Advanced settings) - that lights both LED's on the remote.
"Spooky Boost produces the difference between the 2 generator outputs. Earlier versions of Spooky2 produced an output signal even if the frequencies of the 2 outputs were the same. Because of USB instruction delay, the waveforms were out of phase. Spooky2 now synchronizes the 2 outputs. If the signals are identical in amplitude, phase and frequency, then there is no difference between them, and no output will be produced. Spooky Boost usually uses "Inverse + Sync" to maximize output power. Inverting OUT2 will provide the greatest difference between the generator outputs. Doubling the voltage quadruples the power. P = V^2 / R where P = power, V = voltage and R = resistance. R is constant, so the power is proportional to the square of the voltage."
Current settings -
Duty Cycle 50%
Amplitude 20V
.o5% Feathering
Skip Concurrent Duplicate Frequencies
Remove Duplicate Frequencies
Sort Frequencies Ascending
F2 = F1 X 11Hz | 0 Percent
Modulate F2 using F1 (AM DSB)
i've run a set of Frequencies for past few days.
Have used square wave X1 (now running with X10) & also -
Damped Sinusoidal X11
Have also tried Sine Wave X1
(don't know how much difference it makes changing the X value & spike length/ratio on the wave forms?)
Inverse & Sync on out 2.
|